MC122 - MCP-4J Control Unit Appendix B - System Connectivity
129
MCP-4 - Continued
4. Change the IP Address option to ‘192.168.30.91’
5. Restart the system using the main power switch.
Plugging the Control Gluer System in the BC7 Cabinet
The control gluer system needs to be connected into the B7 Cabinet by plugging an Ethernet cable into a network
port. The BoxChek7 Cabinet can support up to 2 x 4-port network camera cards. Depending on how many devices
are connected to the Cabinet, the system may have one or two 4-port network camera cards.
If BC7 Cabinet has one network card, the Control Gluer System should be connected through the port “NIC3”. If BC7
Cabinet has a second network card, the Control Gluer System should be connected through the port “NIC7”.
Login in BC7 System as Level 4 user, select the required option, and follow its instructions.
Gluer Connection Setup with 1 Network Card
1. Exit the BC7 Application and access the Windows Desktop environment.
2. Navigate to Control Panel → Network and Internet → Network and Sharing Center → Change Adapter
Settings.
To Next Page
Loading...
Need help?
General