Section 4 - Programming MC122 - MCP-4J Control Unit
60
Jam Setup Menus
Enter the Jam Setup Menu in the Settings Menu.
Machine Stop Output:
This setting enables or disables the machine stop output. This output uses the relay output on the back of the MCP-
4J. There is both a normally-closed contact and a normally-open contact. The Relay output is the male M12 on the
back connector panel, with the relay symbol next to it (
). Brown and Black (Pins 1 & 4) are common, White (Pin 2)
is normally CLOSED, and Blue (Pin 3) is normally OPEN.
When enabled:
• If a jam is detected, the relay will turn on.
See the Rearm Mode section, below, for information on how the relay turns off.
Beacon Output:
This setting enables or disables the beacon output. This will turn on the red beacon output at the standard Valco
beacon light (481XX057).
X2
X3
To Next Page
Loading...
Need help?
General