Vemco VR100 - Verify Code Maps; Select Backlight and Contrast Setting; Backlight; Contrast

VEMCO – VR100 Manual 28 May 2018 14
2.1.4 Verify Code Maps
There are four default code maps used with VEMCO coded tags:
 MAP-114 for 69 kHz (Current)
 MAP-113 for 69kHz (Legacy)
 MAP-414 for 180 kHz
 MAP-311 for 81 kHz
These maps are installed by default but it is wise to verify that these default maps are the ones on which your
tags operate. For more information, see section 7.1.1.
2.1.5 Select Backlight and Contrast Setting
You can adjust these settings as needed, depending on your working environment lighting.
2.1.5.1 Backlight
There are three options available for backlight operations, ON, OFF, and SMART. The ON option turns the
backlight on and it remains on until it is turned off using the OFF option. The backlight should only be
needed indoors and at night. Operating the VR100 with the backlight on will greatly reduce the operating
time between battery charges. The SMART option leaves the backlight off if the keypad is inactive but will
turn the backlight on for five seconds when a button is pressed on the keypad.
To change the backlight setting, from the Main screen:
1. Select Config (see section 6.1.2.1).
2. Press “2” on the keypad.
3. Press “3” on the keypad. The current backlight setting is displayed with an arrow symbol.
4. Press the up or down arrow button until the desired option is shown on the display.
5. Press the button attached to “Accept” to accept the change, or “Cancel” to exit the menu without
changing the backlight setting.
2.1.5.2 Contrast
The contrast between the text and the background on the VR100’s screen can be adjusted. The contrast
should be set so the text on the screen is clearly visible without any of the background lines being visible.
To adjust the contrast, follow the steps below. From the Main screen:
1. Select Config (see section 6.1.2.1).
2. Press “2” on the keypad.
3. Press “2” on the keypad.
4. Use the left selection button to decrease the contrast (Less) or the right selection button to increase
the contrast (More) to the desired level.
5. Press the MENU button to accept the changes.