Vemco VR100 - Manually Adding Devices

VEMCO – VR100 Manual 28 May 2018 34
STEP 4
Select the desired unit from the list of receivers by either moving
through the list using the direction arrow buttons and then pressing
the right selection button (under “Select” on the display), or by
pressing the associated number on the keypad. For example,
pressing the “2” button on the keypad will select VR2AR serial
number 12346.
The rest of the units will wait in case you want to talk to them after
you’re finished with your first selection (i.e. you don’t have to scan
again).
Press the “Menu” button to go back.
4.4.1.2 Adding Devices
You can manually add devices by entering their serial number.
STEP 1
Select “Add Device…” (#2) in
the main screen.
STEP 2
Enter the Device Serial Number
using the up/down arrows, then
select “Next”.
STEP 3
The device can then be
communicated with.
If you add a device and try to talk
to it but don’t get a response, it
will disappear from the list if you
back out of the Transponding
menu or power cycle the VR100.
1 VR2AR:012345 85m
2 VR2AR:012346 105m
3 VR2AR:012344 100m
Select
1 Auto Scan
2 Add Device...
3 Manual Scan...

Select
Enter device serial
Number:
_ _ _ _ _ _
↕
Next
TIP: Receivers listed with
a range are active.
1 Status SN:012345
2 Settings
3 Acoustic Release

Select