VEMCO – VR100 Manual 28 May 2018 66
6.6.3.1 Open a Resource file
Open a resource file (see section 6.6.3) to retrieve sensor tag setups. A resource file is opened by following
the steps below while in the VR100 Receiver window.
1. Select Tag Manager in the Settings menu of the VR100 Receiver window (see section 3.3).
2. Select Open in the File menu of the Tag Manager window (see section 3.8).
3. Select the desired file in the Open window. It may be necessary to move to a different directory,
depending on where the resource file was saved.
4. Click the “Open” button or double click the file name.
When a resource file is open, the sensor tag setups contained in that file are shown in the PC Managed Setup
half (left side) of the Tag Manager window.
6.6.4 Raw Files
RAW files are automatically saved in the Raw Data Directory (see section 3.9) when data is loaded from the
VR100 receiver. These files, named VRDxxx.zraw where each x represents an integer, are not user-readable
and are solely used by VEMCO for diagnostic or data recovery purposes. The raw files can be deleted
without affecting the operation of the VR100 if disk space is required on the computer but deletion is not
necessary. It’s suggested that the files are not erased until after data has been successfully recorded.
To Next Page
Loading...
