Vemco VR100 - How Do I View a Channels Setup Without Changing the Setup; What Is an Event and How Do I Know if I Have any; VR100 PC Software Related Questions; How Do I Load the Vr100 S Tag Setup to the PC

VEMCO – VR100 Manual 28 May 2018 77
7.2.6 How do I view a channel’s setup without changing the setup?
The channel configuration can be either viewed or edited. How to edit the configuration is explained in
section 2.3. How to view the configuration is described in the steps below.
From the Main screen:
1. Select Config (see section 6.1.2.1).
2. Press “1” on the keypad.
3. Select the desired channel number on the keypad and press the right selection button for “Configure”.
The channel’s configuration is displayed in a summary screen.
4. Select “Accept” (right selection button), or press the MENU button, to return to the Channel window
without making changes to the channel’s configuration.
7.2.7 What is an event and how do I know if I have any?
An event is either a detected ping from a tag, a GPS position fix, or a system action (like a start-up, a change
to the receiver’s configuration, etc.). The number of events increases until the memory is full at
approximately 85000 events. The number of events stored in a VR100 can be viewed in the Event Log screen
(see section 4.3.2).
7.3 VR100 PC Software Related Questions
7.3.1 How do I load the VR100’s tag setup to the PC?
Simply save the tag setup as explained in section 3.8.4. This creates a resource file (see section 6.6.3) that
can be used with multiple VR100 receivers and on multiple PCs.