Vemco VR100 - Common Questions and Answers

VEMCO – VR100 Manual 28 May 2018 74
7 Common Questions
7.1 General Questions
7.1.1 What is a code map?
There are four default code maps used with VEMCO coded tags:
 MAP-113 for Legacy Default for 69kHz
 MAP-114 for 69 kHz (current)
 MAP-414 for 180 kHz and
 MAP-311 for 81 kHz.
These maps are installed in the VR100 by default. Several legacy maps can be installed on the receiver using
the VR100 PC software, but should only be used if directed by VEMCO Customer Support. The current
default map definitions are listed below.
Map Name
Notes
MAP-113
Legacy Default Map for 69kHz Coded Tags
MAP-114
*
Current Default Map for 69 kHz Coded Tags
MAP-311
Default Map for 81 kHz Coded Tags
MAP-414
Default Map for 180 kHz Coded Tags
* MAP-114 also contains additional code spaces not yet released
IMPORTANT: VEMCO tag datasheets will contain a Code Space name which fully defines the tag
parameters necessary for the receiver. Ensure that you select a Code Map that contains all the code spaces
required for your tags.