VEMCO – VR100 Manual 28 May 2018 62
AGC button
The AGC (Automatic Gain Control) button toggles the gain level between automatic (AGC) and manual.
Use of the button is explained in section 4.2.1. AGC is explained in the Glossary (section 9.5).
Numeric keypad
The numeric keypad is used to enter numbers while configuring the receiver or to select specific channels
while monitoring tags.
Power buttons
The power buttons turn on and off the VR100 receiver. The ON button will turn the VR100 on and
display the welcome screens while the receiver is booting up. The OFF button will begin the VR100’s
shut-down procedure.
Battery charge indicators
The battery charge indicators show the status of the battery charging process and indicate when the battery
charge is low. More details about charging the battery are found in section 5.2.
GPS antenna
The GPS antenna is contained inside the plastic “puck” for protection and attached to the front panel.
The GPS antenna is able to receive the GPS signals when the VR100 is outdoors, even with the case lid
closed. More information about the GPS is located in section 6.8.
To Next Page
