Vertical comdial DX-120 - Page 326

BASIC CALL HANDLING PROGRAMMING TASKS DX-120 Programming Manual
- 318 -
Setting DISA via the DET (continued)
Programming the DISA DAY COS:
From the DB Item Select screen (see steps 1 through 3 on page 315):
4) Enter 03-47-03-XXX-02 (where XXX represents the appropriate directory number: 800~839).
5) Press save to display the DISA CO Line.
6) Press chg until you see the class of service you want to use for this CO line directory number during
daytime hours.
• Valid entries are 0 through 7.
• The default is 0.
7) Press next to advance to DISA EVE COS (now go to step 6 in “Programming the DISA EVE COS:”
below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Programming the DISA EVE COS:
From the DB Item Select screen (see steps 1 through 3 on page 315):
4) Enter 03-47-03-XXX-03 (where XXX represents the appropriate directory number: 800~839).
5) Press save to display the DISA CO Line.
6) Press chg to assign the class of service you want to use for this CO line directory number during evening
hours.
• Valid entries are 0 through 7.
• The default is 0.
7) Press next to display SERVICE mode (now go to step 6 in “Programming the Service Mode:” below).
OR
Press the volume UP button to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Setting DISA via the DET (continued on next page)