- 53 -
DX-120 Programming Manual BASIC SYSTEM PROGRAMMING TASKS
Setting System Time, Date, and/or Hour Mode (continued)
Change the Date:
From the Select screen (see steps 1 through 3 above):
4) Enter 08-14-03 to display the current date.
5) Press chg.
6) Enter 2 digits for the new date setting.
HINT
You must always use a two-digit format: if you want to set the date for the 9th, you
would need to enter it as 09.
7) Press save.
8) Press next to go to the month setting (now go to step 5 “Change the Day of the Week:” below).
OR
Press the Volume button (up or down) to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Change the Day of the Week:
You can continue from step 8 above or:
From the Select screen (see steps 1 through 3 on page 52):
4) Enter 08-14-04 to display the day of the week.
5) Press chg until the day of the week you want is displayed.
6) Press next to go to the month setting (now go to step 5 “Change the Hour:” below).
OR
Press the Volume button (up or down) to return to the DB Item Selection screen.
OR
Exit programming (see “Exiting Database Administration” on page 27).
Setting System Time, Date, and/or Hour Mode (continued on next page)
To Next Page
Loading...
