Vertical Wave - Feature Keys & Functions

infinite Executive and Enhanced Phones - 24 Button 6-26
About Wave Digital Phones
Wave Phone User Guide
Feature Keys & Functions
Feature Used to …
1
Handset Answer or place an internal or external call.
2
Speaker Hear the other party during a call without using the handset or headset
(Speaker Mode).
3
Message Wait Light Indicate when you have a new voicemail message.
4
Display View information re: the options and status of your phone. (Executive model)
5
Pre-programmed (PGM)
Buttons (24)
Perform special phone functions, pre-programmed by the System
Administrator.
6
FLASH Button Access many of the features of this phone (such as when making calls,
transferring calls, or putting calls on hold). Refer to the Feature Code Guide
at the end of this chapter.
7
TRANS Button Place a call on hold while you dial the destination extension number when
transferring calls or creating conference calls.
8
(Sys) SPEED Button Access/dial pre-programmed speed dial numbers
9
CONF Button Reconnect (or toggle between) calls on hold, during call transfer, and when
creating conference calls. Also, while dialing, pressing this button once will
erase the last dialed digit and pressing it twice will clear all the dialed digits.
10
MSG Button Access user voicemail.
NOTE: Typically, a phone has only one programmed Message or Message
Waiting button for that extension. However, some phones may have additional
Message Waiting buttons. One reason for having these additional buttons
would be if an assistant is responsible for listening to his/her boss’s voicemail,
or a supervisor is responsible for retrieving voicemail messages for a
department, and so forth.
11
FWD Button Send unanswered, incoming calls to another designated number
12
MUTE Button Prevent the distant party from hearing any conversation at your end.
13
CAMP ON Button Access a second level of AutoDial buttons.
14
ON/OFF (Speaker) Button Switch to Speaker mode to hear a caller instead of holding the handset.
15
HOLD Button Place a call on hold and keep the party connected while you hang up the
handset or use other phone features.
16
Microphone Speak to a caller when using the speaker instead of holding the handset.
17
HTP (not supported) Used to select mode of operation: Handsfree, Tone, or Privacy.
18
VOLUME Up/Down Buttons Increase / Decrease the loudness of the speaker or handset while on a call.
Note: Flexible buttons must be assigned in ADMIN programming.
Wave 4.0
June 2013