Conference Calls 3-25
Using Wave Phone Features
Wave Phone User Guide
ANALOG PHONES
To Access Centrex Flash
1. Listen for the dial tone, then press *80.
2. Enter a Centrex feature code.
Conference Calls
You can set up a conference call that includes both internal and external parties. If you have a
Conference ( ) button or a Flash button, you can set up a conference call. Contact your
System Administrator for the maximum number of parties allowed on a single conference call.
Setting Up a Conference Call [ALL]
SIP PHONES
To Set Up a Conference Call Using the Conference () Button
With a party on the line:
1. Press Conference ( ) to place the other party on hold.
On some models, there is a
CONF softkey.
Note: For the 55i and 57i SIP phones -- although the Conf softkey is displayed when the
phone goes off-hook, Conference is not supported when the phone is in the dialing state.
2. Listen for the dial tone, then dial the number of the next party.
3. When that party answers, press Conference ( ) again to connect the calls.
• If a party is not available, press End Call to reconnect to the first party.
• For 480i/CT, 9480i/CT, and all Aastra Series 5 models: press Goodbye ( to
reconnect to the first party.
Repeat steps above for each party you want to include in the conference (up to
the allowed maximum).
When all parties have been connected:
4. Press Conference ( ) one more time to complete the set up process and
begin the conference call between all current parties.
To Next Page
Loading...
