Direct Station Select/Busy Lamp Field (DSS/BLF) 3-29
Using Wave Phone Features
Wave Phone User Guide
Direct Station Select/Busy Lamp Field (DSS/BLF)
DSS/BLF buttons allow you to perform certain functions with only one press of a button (such
as calling an extension or transferring a call, and so forth). Features available on these buttons
depend upon how they are programmed for your phone. Contact your System Administrator for
details.
IMPORTANT: DSS/BLF keys are configured by the System Administrator or by user
programming and can be configured for either blind or supervised transfer. If the DSS/BLF
button's programming has Blind Transfer enabled, a blind transfer will be attempted when the
button is pressed. If not, a supervised transfer will be attempted instead.
A solid red LED next to a DSS/BLF button
indicates that the line is in use. A flickering red LED
indicates the extension is ringing. A blinking LED indicates that the extension has a call on hold.
Using the DSS/BLF Feature [D]
DIGITAL PHONES
Calling an Extension
Press the DSS/BLF button to call the programmed destination extension.
Using Supervised Transfer
A supervised transfer allows you to announce a call before completing the transfer.
To Make a Supervised Transfer
While connected to another party:
1. Press the DSS/BLF button for the destination extension.
2. When the destination party answers, announce the call.
3. Hang up or press SPEAKER to complete the transfer.
To Cancel a Supervised Transfer
Press TAP to cancel the transfer before completion.
To Next Page
Loading...
