Hold 3-41
Using Wave Phone Features
Wave Phone User Guide
Placing a Call on Hold [ALL]
SIP PHONES
To Place a Call on Hold
Press Hold ( ) on models 9133i or the button labeled Hold on all Aastra
Series 5 models.
The LED flashes next to the line button with a call on hold.
You can hang up the handset or use other phone features.
If you leave the call on hold for too long, your phone rings back to
remind you.
Note: The Flash button can be used to place calls on temporary hold. When you do so,
you will hear dial tone. If you press TAP, you will be reconnected to the call on hold; if you
hang up the handset the call on hold will immediately recall.
To Reconnect to a Call On Hold
Press the button corresponding to the line at which the call was placed on hold.
Using the Reconnect Softkey (Models 480i/CT and 9480i/CT only)
Use the
RECONNECT softkey to reconnect to a call that is on hold or parked.
DIGITAL PHONES
To Place a Call on Hold
Press HOLD.
When a call is on hold, the red LED flashes next to the corresponding line or call
appearance button.
You can hang up the handset or use other phone features.
If you leave the call on hold for longer than the system hold time (three minutes is the
default), your phone rings back and
HELD is displayed.
Note: The Flash button can be used to place calls on temporary hold. When you do so,
you will hear dial tone. If you press Flash again or hang up the handset, you will be
reconnected to the call on hold.
To Next Page
Loading...
