Page 3-51
Using Wave Phone Features
Wave Phone User Guide
Page
The Page feature can operate in one of two ways: the Page button gives you access to the public
address system and all the phone speakers on your system, or pages only a specific zone (group)
of phones.
Making and receiving a SIP page
• When you initiate a page from phone, a confirmation tone alerts you when the system is
ready to broadcast paging.
• When you receive a page, an alert tone signals that page playback is about to begin.
• When an SIP phone is receiving a page, incoming calls will not be audible until the page
is complete. The user may answer the incoming call and the page announcement will
cease.
• When an SIP phone user initiates a page to a zone they are part of, that user will not hear
the page.
• A SIP phone user can initiate a call while receiving a page announcement. The page
announcement will cease to that phone when the user places a call.
Paging the Entire System [ALL]
Hint: Telephones receiving a page on the phone speaker can press SPEAKER to disconnect the
phone from the paging service.
SIP PHONES
To Page All Phones with Speakers
1. Press Intercom ().
If your phone does not have an Intercom button as shown above, dial *11.
2. Make an announcement.
3. Hang up or press End Call when you are finished making your announcement.
For 480i/CT, 9480i/CT, and all Aastra Series 5 models: press Goodbye ( ) or use the
DROP softkey.
Note: When receiving a page on the phone speaker, you can press
End Call, or for 480i/CT, 9480i/CT, and all Aastra Series 5 models: press Goodbye ()
to disconnect the phone from the paging service.
To Next Page
Loading...
