User Programmable Buttons (On the Phone or Console) 3-69
Using Wave Phone Features
Wave Phone User Guide
Using Programmable Keys [D]
DIGITAL PHONES
Programming a Feature Button
Note: Not all feature keys are user programmable, thus you cannot edit a button that is not in
the above list. Display the feature information as described above to determine which keys are
available for programming.
In addition, some digital phones have a programmed “Program” button which takes you to the
same location on the display as steps 2 and 3. See “Program Button” on page 6-41
From an idle phone:
1. Decide which button you want to program.
2. Press the
MENU softkey on the display.
3. Press
NEXT until PROG appears, then press the corresponding button.
4. Press
Next until the desired feature is displayed, then press the corresponding
button.
5. Press the button you wish to program.
If additional options are available (such as an extension for User Forward or Blind
Transfer for DSS/BLF) you will be prompted at this point to enter the information.
6. Press SPEAKER to clear the display.
To Clear a Feature Button
Follow the above steps, and program the button as “Unassigned”.
Note: Vodavi/Triad/Infinite phones can not be programmed through the phone.
Using the Query Feature (phone models with displays only)
A query of a feature button will display what feature has been programmed onto the button.
To Display Feature Information
From an idle phone:
1. Press the MENU softkey on the display.
2. Press a feature button.
The feature button information is shown on the display including the feature name,
button number, and extension number, target number, or programmed number if
applicable.
3. Press SPEAKER to clear the display.
To Next Page
Loading...
