Conference Calls 3-27
Using Wave Phone Features
Wave Phone User Guide
When the other party answers:
3. Press TRNS/CONF or TRANS button again to connect the calls.
The number of parties in the current conference call will appear on the display.
If a party is not available, press TAP, or press the button corresponding to the initial call to
reconnect to the first party.
4. Press TRNS/CONF or TRANS again to place the conference call on hold and
add a fourth party.
Repeat steps 2 through 4 to add additional parties.
5. Complete the conference by pressing TRNS/CONF or TRANS.
ANALOG PHONES
To Set Up a Conference
With a party on the line:
1. Press Flash, then #.
2. Dial the phone or extension number of a conference member.
After the conference member answers:
3. Press Flash and #, then press *71.
or,
4. Press Flash, then 5.
Repeat for each additional conference member.
If you dial a member that is not available
Press Flash, then 4 to return to the conference.
To Next Page
Loading...
