Energy Saving Mode Activation
NOTE: Read this manual carefully before activating Energy Saving Mode. An Operator can only enable or disable
Energy Saving Mode. The available modes vary according to the UPS type and system configuration. The types
available must be set up by either Administrator or Service personnel.
Energy Saving Mode may be activated or deactivated through the OPERATE menu screen. Two modes are available as Eco
Mode and Intelligent Parallel Mode.
Eco Mode permits the UPS to reduce power consumption by powering the load through bypass power when utility supplied
power is within acceptable ranges. The inverter will remain in a state that will permit it to resume supplying power if the utility
power goes outside acceptable ranges.
Intelligent paralleling puts units in a sleep mode until required.
To activate or deactivate Energy Saving Mode:
1. Touch the Setup radio button for Energy Saving Mode Activation.
2. Enable or disable Energy Saving Mode.
3. Touch the Save button. The Save button is inactive until the activation state is changed.
Figure 5.22 Activating Energy Saving Mode
74 Proprietary and Confidential ©2023 Vertiv Group Corp.
5 Operator Control and Display
Panel
Vertiv™ Liebert® APM2 30 to 120 kVA Modular UPS User Manual
To Next Page
Loading...
