Vertiv™ | Liebert
®
STS2
™
100-1000A, 50/60Hz User Manual | Rev. 12 | 11/2017 3
1.0 SAFETY PRECAUTIONS
Read this manual thoroughly before working with the Liebert STS2.
Be sure to review the warning under Important Safety Instructions on page 1.
Refer to the Handling Considerations on page 5 before attempting to move the unit.
Under typical operation and with the doors closed, only normal safety precautions are necessary. The area
around the Liebert STS2 must be kept free from puddles of water, excess moisture and debris. The vent grate in
the front of the system must not be obstructed in order to ensure a smooth air flow through the unit for cooling.
ONLY qualified service personnel should perform maintenance on the Liebert STS2. When performing
maintenance on any part of the equipment under power, service personnel and test equipment should be
located on rubber mats. The service personnel should wear insulating shoes for isolation from direct contact with
the floor.
Unless all power is removed from the input sources to the unit, one person should never work alone. A second
person should be on hand to assist and summon help, should an accident occur.
Three types of messages are used throughout this manual to stress important text. Carefully read the
information below each Warning, Caution and Note and use professional skills and prudent care when
performing the actions described in that text.
A Warning indicates the presence of a possible serious, life-threatening condition. For example:
A Caution indicates a condition that could seriously damage the equipment and possibly injure personnel. For
example:
A Note emphasizes important text. If the instructions are not properly followed, the equipment could be
damaged or may not properly operate. For example:
WARNING
The unit is supplied by more than one power source. The Unit contains hazardous voltages if any of the
input sources is ON, even when the unit is in bypass. To isolate the unit, turn OFF and lock out ALL input
power sources.
Verify that all input power sources are de-energized and locked out before making connections inside
unit.
Lethal voltages exist inside the unit during normal operation. only qualified service personnel should
perform maintenance on the static switch.
CAUTION
Risk of unit damage
The input sources to the static switch must be grounded-wye sources. input sources other than solidly
grounded-wye sources may cause damage to the switch.
NOTE
Read this entire manual before installing and operating the unit.
To Next Page
Loading...
