Vertiv™ | Liebert
®
STS2
™
100-1000A, 50/60Hz User Manual | Rev. 12 | 11/2017 8
4.0 LOCATING THE LIEBERT STS2
This section provides instructions for leveling the Liebert STS2 and anchoring the unit to the floor, should that
be required.
For leveling feet details, see Figures 4 through 9.
4.1 Leveling and Anchoring the Unit to the Floor
The Liebert STS2 can be anchored to the concrete floor to ensure stability for the unit in the event of seismic
activity.
The seismic brackets are an option for the Liebert STS2 and are shipped separately from the unit when ordered.
See Figures 10 through 12 for instructions and details for installing seismic anchoring.
4.2 Leveling of the Static Switch Without Anchoring
The Liebert STS2 is furnished with casters and leveling feet. After final positioning of the unit, adjust the leveling
feet located in each corner of the frame base to level and stabilize the unit.
4.3 Leveling and Anchoring the Static Switch Using Floor Stand
The Liebert STS2 can be installed using the optional floor stand to support the unit instead of using the raised
floor. The Liebert STS2 can be rolled or placed using a lift on to the floor stand.
After final positioning of the unit, adjust the leveling feet located in each corner of the frame base to level and
stabilize the unit.
The floor stand can also be used to ensure the unit’s stability in the event of seismic activity by anchoring the
Liebert STS2 to the floor stand and to the concrete floor.
The seismic floor stand is shipped separately from the unit when ordered.
See Figures 29 through 40 for instructions and details for installing seismic floor stand.
To Next Page
Loading...
