Vertiv™ NetSure™ Control Unit (NCU) User Manual
On: When a new alarm occurs, the audible alarm sounds. Press any key to silence the audible alarm.
3 min / 10 min / 1 hr / 4 hrs: When a new alarm occurs, the audible alarm sounds. The audible alarm
automatically silences after the selected time period.
IP Address Sub-Menu
DHCP: The DHCP function allows the controller to acquire an IP address automatically. This function can only be
enabled or disabled via the local display and keypad. If this function is enabled and the acquisition of an IP address
fails, an alarm is generated. If the acquisition of an IP address is successful, you need to record the IP address
automatically acquired by the controller to access the controller via the Web Interface. This IP address is displayed in
the IP Address field below the DHCP setting in the local display menu (Main Menu / Settings Icon / Comm Settings).
IP Address: Sets the controller's IP address. Enter the address in the format nnn.nnn.nnn.nnn, where
0 ≤ nnn ≤ 255. The address must be a valid address and must not be 255.255.255.255.
Mask: Sets the controller's network netmask. Enter the address in the format nnn.nnn.nnn.nnn, where
0 ≤ nnn ≤ 255.
Default Gateway: Sets the controller's gateway address. Enter the address in the format nnn.nnn.nnn.nnn,
where 0 ≤ nnn ≤ 255. This is the address of the gateway of the network on which the controller resides. The address
must be a valid address and must not be 255.255.255.255.
• Over Voltage 1: Sets the Over Voltage 1 alarm point.
• Over Voltage 2: Sets the Over Voltage 2 alarm point.
• Under Voltage 1: Sets the Under Voltage 1 alarm point.
• Under Voltage 2: Sets the Under Voltage 2 alarm point.
• Conv Volt Set: Sets the output voltage for all converters.
• System Temp1: Sets system temperature port 1 to None, Battery, or Ambient.
• System Temp 2: Sets system temperature port 2 to None, Battery, or Ambient.
• IB2-1 Temp 1: Sets temperature port 1 on the IB2-1 board to None, Battery, or Ambient.
• IB2-1 Temp 2: Sets temperature port 2 on the IB2-1 board to None, Battery, or Ambient.
• IB2-2 Temp 1: Sets temperature port 1 on the IB2-2 board to None, Battery, or Ambient.
• IB2-2 Temp 2: Sets temperature port 2 on the IB2-2 board to None, Battery, or Ambient.
• EIB-1 Temp 1: Sets temperature port 1 on the EIB-1 board to None, Battery, or Ambient.
• EIB-1 Temp 2: Sets temperature port 2 on the EIB-1 board to None, Battery, or Ambient.
• EIB-2 Temp 1: Sets temperature port 1 on the EIB-2 board to None, Battery, or Ambient.
• EIB-2 Temp 2: Sets temperature port 2 on the EIB-2 board to None, Battery, or Ambient.
• SMTemp# Temp #: Sets temperature port # on the SM-Temp # module to None, Battery, or Ambient.
To Next Page
Loading...
Need help?
General
