Vertiv NetSure M830B - Page 188

Vertiv™ NetSure™ Control Unit (NCU) User Manual
178
Web
Interface Tab
Signal Manual Mode
Authority Level
Required - Web
Authority Level
Required - LCD
IPV6 DHCP – Server IP -- Administrator Operator
Advanced Settings / Users User Information (delete command) -- Administrator not available
Add or Modify User – User Name -- Administrator not available
Add or Modify User – Privilege -- Administrator not available
Add or Modify User – Confirm -- Administrator not available
Advanced Settings / SNMP Accepted Trap Level (not used/all/major/critical) -- Administrator not available
NMSV2 Configuration - delete command -- Administrator not available
NMSV2 Configuration – NMS IP -- Administrator not available
NMSV2 Configuration – Public Community -- Administrator not available
NMSV2 Configuration – Private Community -- Administrator not available
NMSV2 Configuration – Trap (enable/disable) -- Administrator not available
NMSV3 Configuration – delete command -- Administrator not available
NMSV3 Configuration – User Name -- Administrator not available
NMSV3 Configuration – Priv Password DVS -- Administrator not available
NMSV3 Configuration – Auth Password MD5 -- Administrator not available
NMSV3 Configuration –Trap (enable/disable) -- Administrator not available
NMSV3 Configuration – Trap IP -- Administrator not available
NMSV3 Configuration – Trap Security Level -- Administrator not available
Advanced Settings /
Language
Local Language (select) -- Administrator Operator
Advanced Settings / SW
Maintenance
Auto Config -- Administrator Operator
Restore Factory Defaults -- Administrator Operator
Retrieve SettingParam.tar -- Administrator not available
Upload/Download -- Administrator Operator
Advanced Settings /
Alarms
New Alarm Level -- Administrator not available
New Relay Number -- Administrator not available
Advanced Settings / DI
Alarms
Signal Full Name -- Administrator not available
Signal Abbreviated Name -- Administrator not available
New Alarm Level -- Administrator not available
New Relay Number -- Administrator not available
New Alarm State -- Administrator not available
Advanced Settings / DO
(Relay)
Relay Test (enable/disable) -- Administrator not available
Relay Test Time (sec) -- Administrator not available
Each Relay (energize/de-energize) -- Administrator not available
Signal Full Name -- Administrator not available
Advanced Settings /
Shunts
Set type (Not Used/General/load/Battery/Source) -- Administrator not available
Signal Full Name -- Administrator not available
Signal Abbreviated Name -- Administrator not available
Full Scale Current (A) -- Administrator not available
Full Scale Voltage (mV) -- Administrator not available
Break Value (A) -- Administrator not available
High 1 Curr Limit Alarm (A) -- Administrator not available