Vertiv™ NetSure™ Control Unit (NCU) User Manual
Radius Server Settings
Enter the following radius server settings as applicable.
1. Enable Radius: Check this box to enable the radius server authentication feature. The NCU will check the radius server for
password authentication.
2. NAS-Identifier: Check this box to use the Site Name as the NAS-Identifier. If checked, the “Site Name” programmed into the
NCU is sent as the NAS-identifier in the authorization request.
3. Primary Server: The IP address of the primary radius server.
4. Primary Port: The port number on the primary radius server used to access the radius interface (default 1812).
5. Secondary Server: The IP address of the secondary radius server (optional). The NCU will authenticate using the secondary
server if the primary server in unreachable.
6. Secondary Port: The port number on the secondary radius server used to access the radius interface (default 1812)
(optional). The NCU will authenticate using the secondary server if the primary server in unreachable.
7. Secret Key: A secret key phrase (1 to 31 alphanumeric characters; all ASCII characters valid). This secrete key phrase is sent
to the radius server with the authorization request so the server knows it is a valid request.
8. Confirm: Re-enter the Secret Key to confirm it was typed correctly. The “Secrete Key” entry and “Confirm” entry must match.
9. Click the "Save" button to save the radius server settings.
To Next Page
Loading...
