Vertiv™ NetSure™ Control Unit (NCU) User Manual
<ocrtm>
This is the time when the triggering event occurred. The format for this parameter is HOD-MOH-SOM (Hour-Of-Day -
Minute-Of-Hour - Second-Of-Minute). HOD ranges from 0 to 23. MOH and SOM range from 0 to 59.
A <null> value means this parameter and <ocrdat> are not applicable.
Unimplemented Parameters
The following two parameters do not apply to this application. A <null> value is inserted for them.
<locn> - location of alarm condition
<dirn> - direction of alarm condition
<tmper>
This is the accumulation time period for PM parameters. In this application, it represents the length of time the alarm
condition has been active. The format for this parameter is “VAL-UN”, where valid values for VAL (value) and UN
(units) are given below.
VAL UNIT
1 DAY (days) - used if alarm is active longer than 24 hours.
1 to 24 HR (hours)
1 to 1440 MIN (minutes) - used if alarm is active less than 24 hours.
<conddescr>
This parameter is a text message which provides a detailed description of the alarm, event, or condition. It is an ASCII
string enclosed within a pair of escaped quotes(\”). It may also be used to describe any action to be taken as a result of
the condition.
Unimplemented Parameters
NOTE!
The following parameters will either not be implemented or do not apply to this application. A <null> value is returned
for these parameters.
<aiddet> - supplementary equipment identification
<obsdbhvr> - observed behavior that resulted in reported trouble
<exptdbhvr> - expected behavior that was deviated from
<dgntype> - diagnostic routine used to isolate trouble
<tblistl> - provides isolation information
To Next Page
Loading...
Need help?
General
