Vingtor Stentofon TKIS-2 - Page 26

26
A100K11194
Turbine Station Conguration Guide
Model: (for Ex)
- TFIX-1
- TFIX-2
- TFIX-3
- TFIX-4
Accessory: (for Extended & Ex)
- Handset
- Handsetw/O󰀨hook
- Handsetw/O󰀨hook(NormallyClosed)
- Handheld Microphone
- Headset
- Headset w/ Autodetect
Registration Settings
ICX-AlphaCom IP-Address:
● Enter the IP address of the ICX-500 or AlphaCom serve in which the IP station is to be a
subscriber in the eld.
Number:
● Enter the directory number of the station in the eld.
- If a directory number is not entered, the station will register with its MAC address. The MAC
address is found on the Station Information page and needs to be entered into AlphaPro.
IP Settings
● DHCP – Select this option if the IP station shall receive IP Settings from a DHCP server.
● Static IP – Select this option if the IP station shall use a static IP address. Enter values for:
- IP-address
- Subnet-mask
- Gateway
- DNS Server 1 (option for network administration)
- DNS Server 2 (option for network administration)
- Hostname (option for network administration)
Disable Reset to Factory default settings using frontboard and I/O
● Check the box to disable factory reset using frontboard and I/O
Read IP Address
● Read IP Address enables an unregistered station to speak the IP address when the call
button is pressed. Read IP Address box is checked, i.e. enabled, by default.
Ethernet Speed 10 Mbits/s
● Check the box if the switch is congured to 10 Mbit/s. Default Ethernet speed is 100 Mbit/s.
Enable RSTP (for Industrial & Ex)
● Check the Enable RSTP box to enable RSTP
- RSTP is only required when using redundant networking
● Click SAVE followed by APPLY