Vingtor Stentofon TKIS-2 - Ringlist Settings

46
A100K11194
Turbine Station Conguration Guide
Call
During an active Call the following options are available (avaliable options depend on station type):
Do Nothing: No action executed if the DAK/Input is activated during a call (Default)
Answer/End Call: Answers an incoming call, and ends an active call. Action can be executed either
On Key Press or On Key Release. Has an option to also Answer Group Call.
End Call: Ends an active call. Action can be executed either On Key Press or On Key Release
Answer Call: Answers an incoming call. Has an option to also Answer Group Call.
Transfer Call: The “Transfer Call” function can work in two modes:
• Transfer immediately on key press when destination call number is congured
• Select transfer destination manually. When a destination call number is not congured, a key
press will set the station in “Transfer Mode”, waiting for the user to dial the transfer destination, or
to transfer to a predened destination by pressing a key with “Call” action.
The active call is immediately hung-up if the transfer has progressed. If transfer fails (e.g. destination
not found), the transfer will be aborted.
Park Call: Places a call on hold into a specic parking location (a ctional number) such that the call
can then be picked up by another number.
Hold Call: When a “Call” button is congured to do “Hold Call” during the call, the button has di󰀨erent
functionalities depending on the current state:
Incoming Call: Accept call
Established call: Put call on hold (disable audio)
On hold: Resumes a call (enable audio)
Send DTMF: Sends congured DTMF for key press and key release.
Send Text: Sends congured text for key press and key release. Enter text in the text eld.
Push To Talk: Congure key to behave like a PTT key during active call.
Standby: Standby will reduce the volume of local speaker by a selected dB value, for the duration of
the call or until pressed again.
Defer: Enables you to save the details of a call as it has been logged or updated, and to put o󰀨 any
action until a later stage.
Depending on the type of station and congured accessories, DAK Settings may also show additional
options:
● Module keys 1 .... n (e.g. ECPIR-3P expansion module buttons)
● PTT / M-key
● O󰀨hook
● Onhook
6.12.1 Ringlist Settings
● Log on to the web interface of the station that will be making the call to congure the ringlist of
the stations that should be called.
To congure a ringlist:
● Select EdgeConguration > Direct Access Keys
There are variants of ringlists that can be set such as ringing time intervals, loopback, and ringing
together with previous stations.
L Note that some telephone gateways accept a call immediately on incoming calls – even before the call
has been accepted by the user (telephone). This terminates the ringlist sequence and any subsequent
numbers in the ringlist will never be called. This is solved by placing the gateway number at the end of
the ringlist and disabling the “With Previous” option. Ringlists that include an auto-accepting gateway
will never loop back.