Manual VIPA CPU 21x Chapter 5 Deployment CPU 21x-2BT02 with H1 / TCP/IP
HB103E - Rev. 05/45 5-15
The CP section of the CPU 21x-2BT02 may only be configured with
WinNCS from VIPA and consists of the following 3 parts:
• The initial CP configuration,
• configuration of connection modules,
• transfer configuration data into the CP.
This is where the address and other identification parameters of a station
are defined.
Under "Ethernet" you insert a new station into the network window and
enter the configuration data for your station into the parameter window.
The basic CP configuration determines the behavior of your station on the
network.
CP configuration
with WinNCS
Initial CP
configuration
To Next Page
Loading...
