virtual access GW1000M Series - Page 120

15: Configuring DHCP server and DNS (Dnsmasq)
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 120 of 350
Web Field/UCI/Package Option
Description
Web: Hostname
UCI: dhcp.@host[0].name
Opt: name
Displays the hostname of the client.
Web: IPv4 Address
UCI: dhcp.@host[0].ip
Opt: ip
Displays the IP address of the client.
Web: MAC Address
UCI: dhcp.@host[0].mac
Opt: mac
Displays the MAC address of the client.
Web: Lease time remaining
UCI: n/a
Opt: n/a
Displays the remaining lease time.
Table 37: Information table for active leases section
15.2.6 Static leases
Use static leases to assign fixed IP addresses and symbolic hostnames to DHCP clients.
Static leases are also required for non-dynamic interface configurations where only hosts
with a corresponding lease are served. Click Add to add a new lease entry.
Figure 67: The static leases section
Web Field/UCI/Package Option
Description
Web: Hostname
UCI: dhcp.@host[0].name
Opt: name
Defines the optional symbolic name to assign to this static DHCP
entry.
1
Enabled.
0
Disabled.
Web: MAC Address
UCI: dhcp.@host[0].mac
Opt: mac
Defines the hardware address that identifies the host.
Web: IPv4 Address
UCI: dhcp.@host[0].ip
Opt: ip
The IPv4 address specifies the fixed address to use for this host..
Table 38: Information table for static leases