virtual access GW1000M Series - 22 Configuring a Mobile Connection; Configuration Package Used; Configuring a Mobile Connection Using the Web Interface

22: Configuring a mobile connection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 164 of 350
22 Configuring a mobile connection
22.1 Configuration package used
Package
Sections
network
interface
22.2 Configuring a mobile connection using the web interface
Note: if you are creating multiple mobile interfaces, simply repeat the steps in this
chapter for each interface. Multiple interfaces are required for dual SIM or multiple radio
module scenarios. Configuring static routes and/or Multi-WAN can be used to manage
these interfaces.
In the top menu, select Network -> Interfaces. The Interfaces Overview page
appears.
22.2.1 Create a new mobile interface
To create a new mobile interface, in the Interface Overview section, click Add new
interface. The Create Interface page appears. In the examples below 3G has been used
for the interface name.
Figure 89: The create interface page