virtual access GW1000M Series - Exporting a Configuration File

10: Router file structure
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 67 of 350
To remove the contents of a specific folder regardless of the current folder (config2),
enter:
root@VA_router:/ # rm –f /etc/config1/*
Warning: the above command makes irreversible changes.
To copy the contents of one folder into another (config2 into config1), enter:
root@VA_router:/etc/config1# cp /etc/config2/* /etc/config1
10.8 Exporting a configuration file
If you have software versions prior to 72.002, to export a configuration file using the
web interface, go to section 10.8.1
If you have software version 72.002 or above, export a configuration file using the web
interface go to section 10.8.2
To export a configuration file using CLI, for any software version, go to section 10.8.3
10.8.1 Exporting a configuration file using the web interface for software
versions pre- 72.002
The current running configuration file may be exported using the web interface.
In the top menu, select System > Backup/Flash Firmware. The Flash operations
page appears.
Figure 41: The flash operations page
In the Backup/Restore section, select Generate Archive.