9: Upgrading router firmware
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 54 of 350
9 Upgrading router firmware
This chapter describes how to upgrade router firmware. The upgrade process is as
follows:
Firmware is transferred to the device.
Firmware is checked to ensure there are no corruptions.
Firmware is saved to persistent storage.
Data in persistent storage is validated.
To avoid any unrecoverable errors during the process, you must follow several safety
steps described in this chapter.
On successful completion of the process, you can restart the device running the new
firmware.
9.1 Software versions
If you have software versions prior to 72.002, to upgrade firmware using the web
interface, go to section 9.1.2.
If you have software version 72.002 or above, to upgrade firmware using the web
interface go to section 9.1.3.
To upgrade firmware using CLI, for any software version, go to section 9.1.4.
9.1.1 Identify your software version
To check which software version your router is running, in the top menu, browse to
Status -> Overview.
Figure 26: The status page showing a software version prior to 72.002
To Next Page
Loading...