23: Configuring mobile manager
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 178 of 350
To monitor via SSH, login and enter:
logread –f &.
An outgoing SMS message appears.
sendsms 353879876543 ‘hello’
root@VirtualAccess:~# Aug 10 16:29:11 user.notice VirtualAccess
mobile[1737]: Queue sms to 353879876543 "hello"
23.6 Sending SMS from the router
You can send an outgoing message via the command line using the following syntax:
sendsms 353879876543 ‘hello’
root@VirtualAccess:~# Aug 10 16:29:1 user.notice VirtualAccess
mobile[1737]: Queue sms to 353879876543 "hello"
23.7 Sending SMS to the router
The router can accept UCI show and set commands via SMS if the caller is enabled.
Note: commands are case sensitive.
An example would be to SMS the SIM card number by typing the following command on
the phone and checking the SMS received from the router.
uci show mobile.@caller[0].number
To Next Page
Loading...
Need help?
General
