virtual access GW1000M Series - 6 Accessing the Router; Configuration Packages Used; Accessing the Router over Ethernet Using the Web Interface

6: Accessing the router
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 24 of 350
6 Accessing the router
Access the router through the web interface or by using SSH. By default, Telnet is
disabled.
6.1 Configuration packages used
Package
Sections
dropbear
dropbear
system
main
uhttpd
main
cert
6.2 Accessing the router over Ethernet using the web interface
DHCP is disabled by default, so if you do not receive an IP address via DHCP, assign a
static IP to the PC that will be connected to the router.
PC IP address
192.168.100.100
Network mask
255.255.255.0
Default gateway
192.168.100.1
Assuming that the PC is connected to Port A on the router, in your internet browser, type
in the default local IP address 192.168.100.1, and press Enter. The Authorization page
appears.
Figure 10: The login page
The password may vary depending on the factory configuration the router has been
shipped with. The default settings are shown below. The username and password are
case sensitive.
In the username field, type root.
In the Password field, type admin.
Click Login. The Status page appears.