virtual access GW1000M Series - 28 Configuring SNMP; Configuration Package Used; Configuring SMNP Using the Web Interface

28: Configuring SNMP
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 265 of 350
28 Configuring SNMP
SNMP (Simple Network Management Protocol) is an internet-standard protocol for
managing devices on IP networks.
28.1 Configuration package used
Package
Sections
snmpd
access
agent
com2sec
constant
exec
group
heartbeat
informreceiver
inventory
inventory_iftable
monitor_disk
monitor_ioerror
monitor_load
monitor_memory
monitor_process
pass
system
trapreceiver
usm_user
view
The SNMP application has several configuration sections:
System and Agent
Configures the SNMP agent.
Com2Sec
Maps SNMP community names into an arbitrary security name.
Group
Assigns community names and SNMP protocols to groups.
View and Access
Creates views and sub views of the whole available SNMP tree and grants specific
access to those views on a group by group basis.
Trap receiver
Address of a notification receiver that should be sent SNMPv1 TRAPs and
SNMPv2c TRAP2s.
Inform receiver
Address of a notification receiver that should be sent SNMPv2 INFORM
notifications respectively
28.2 Configuring SMNP using the web interface
In the top menu, select Services -> SNMP. The SNMP Service page appears.
28.2.1 System and agent settings
Figure 133: The SNMP service page