21: Configuring a WiFi connection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 161 of 350
wireless.radio0.htmode=HT20
wireless.radio0.ht_capab=SHORT-GI-40 TX-STBC RX-STBC1 DSSS_CCK-40
wireless.radio0.txpower=17
wireless.radio0.country=US
wireless.@wifi-iface[0]=wifi-iface
wireless.@wifi-iface[0].device=radio0
wireless.@wifi-iface[0].mode=ap
wireless.@wifi-iface[0].disabled=1
wireless.@wifi-iface[0].ssid=Test_AP
wireless.@wifi-iface[0].network=lan
wireless.@wifi-iface[0].encryption=psk
wireless.@wifi-iface[0].key=secretkey
21.5 Creating a WiFi in Client mode using the web interface
A WiFi network in Client mode receives a wireless network from another WiFi AP.
Configure the Wifi network in Client mode as described in the above section ‘Configuring
a WiFi interface’, selecting a new interface for the Wireless Network in the Interface
Configuration section. For the examples below the new WiFi interface will be called
‘newwifiClient’
Example:
wireless.@wifi-iface[0].network=newwifiClient
wireless.@wifi-iface[0].mode=sta
In the top menu, select Network -> Interfaces. The Interfaces Overview page
appears. Click Edit in the newly created WiFi Client interface. The Common
Configuration page appears.
Figure 88: The client interface page
To Next Page
Loading...
Need help?
General
