22: Configuring a mobile connection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 165 of 350
Web Field/UCI/Package Option
Web: Name of the new interface
UCI: network.3G=interface
Opt: interface
Allowed characters are A-Z, a-z, 0-9 and _
Web: Protocol of the new interface
UCI: network.3G.proto
Opt: proto
Protocol type. Select LTE/UMTS/GPRS/EV-DO.
Static configuration with fixed address and
netmask.
Address and netmask are assigned by DHCP.
Layer 2 Tunnelling Protocol.
CDMA, UMTS or GPRS connection using an
AT-style 3G modem.
Web: Create a bridge over multiple
interfaces
UCI: network.3G.type
Opt: type
Enables bridge between two interfaces.
Not relevant when configuring a mobile interface.
Web: Cover the following interface
UCI: network.3G.ifname
Opt: ifname
Select interfaces for bridge connection.
Not relevant when configuring a mobile interface.
Table 56: Information table for the create interface page
Click Submit. The Common Configuration page appears. There are three sections in the
mobile interface common configurations:
Configure the basic interface settings such as protocol, service type, APN
information, user name and password.
Set up more in-depth features such as initionalization timeout, LCP echo failure
thresholds and inactivity timeouts.
Assign a firewall zone to the connection.
To Next Page
Loading...
Need help?
General
