virtual access GW1000M Series - Page 269

28: Configuring SNMP
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 269 of 350
Web Field/UCI/Package Option
Description
Web: Group
UCI: snmpd.access[x].group
Opt: group
Specifies the group to which access is being granted.
Web: Context
UCI: snmpd.access[x].context
Opt: context
SNMPv3 request context is matched against the value according to the
prefix below. For SNMP v1 and SNMP v2c, the context must be none.
none
all
Web: Version
UCI: snmpd.access[x].version
Opt: version
Specifies the SNMP version number being used in the request: any,
v1, v2c and usm are supported.
v1
SNMP v1
v2v
SNMP v2
usm
SNMP v3
any
Any SNMP version
Web: Level
UCI: snmpd.access[x].level
Opt: level
Specifies the security level. For SNMP v1 and SNMP v2c level must be
noauth.
noauth
auth
priv
Web: Prefix
UCI: snmpd.access[x].prefix
Opt: prefix
Prefix specifies how context (above) should be matched against the
context of the incoming pdu.
exact
any
all
Web: Read
UCI: snmpd.access[x].read
Opt: read
Specifies the view to be used for read access.
Web: Write
UCI: snmpd.access[x].write
Opt: write
Specifies the view to be used for write access.
Web: Notify
UCI: snmpd.access[x].notify
Opt: notify
Specifies the view to be used for notify access.
Table 94: Information table for access settings
28.2.6 Trap receiver
Trap receiver settings define a notification receiver that should be sent SNMPv1 TRAPs
and SNMPv2c TRAP2.
Figure 138: The trap receiver settings page