Vitals Reference Manual
126 Part No. 79-MAN-04, Rev. I E.H. Wachs
4.
To exit the GPS test, tap the Back button.
Hydraulics Test
When you start the Hydrau-
lics Test, an error message
appears if there is a trans-
ducer error. If you see this
error message, follow the
instructions in “Transducer
Zero Torque Error” at the end
of this section before per-
forming the Hydraulics Test.
1.
Tap to select the FLOW (MIN or MAX), PRESSURE (MIN
or
MAX), and DIRECTION (LH or RH).
2.
Tap the RUN button to start the test. The test for the
selected parameters begins, and the button changes to
read
STOP.
NOTE
To Next Page