WEG CFW700 - Codes and Standards

CFW700 | 63
Technical Specifications
English
8.2.1 Codes and Standards
Table 8.2: Codes and standards
SAFETY
STANDARDS
 UL 508C - Power conversion equipment.
 UL 840 - Insulation coordination including clearances and creepage distances
for electrical equipment.
 EN61800-5-1 - Safety requirements electrical, thermal and energy.
 EN 50178 - Electronic equipment for use in power installations.
 EN 60204-1 - Safety of machinery. Electrical equipment of machines. Part 1:
General requirements.
Note: The final assembler of the machine is responsible for installing an safety
stop device and a supply disconnecting device.
 EN 60146 (IEC 146) - Semiconductor converters.
 EN 61800-2 - Adjustable speed electrical power drive systems - Part 2: General
requirements - Rating specifications for low voltage adjustable frequency AC
power drive systems.
ELECTROMAGNETIC
COMPATIBILITY
(EMC)
 EN 61800-3 - Adjustable speed electrical power drive systems - Part 3: EMC
product standard including specific test methods.
 EN 55011 - Limits and methods of measurement of radio disturbance
characteristics of industrial, scientific and medical (ISM) radio-frequency
equipment.
 CISPR 11 - Industrial, scientific and medical (ISM) radio-frequency equipment
– Electromagnetic disturbance characteristics - Limits and methods of
measurement.
 EN 61000-4-2 - Electromagnetic compatibility (EMC) - Part 4: Testing and
measurement techniques - Section 2: Electrostatic discharge immunity test.
 EN 61000-4-3 - Electromagnetic compatibility (EMC) - Part 4: Testing
and measurement techniques - Section 3: Radiated, radio-frequency,
electromagnetic field immunity test.
 EN 61000-4-4 - Electromagnetic compatibility (EMC) - Part 4: Testing and
measurement techniques - Section 4: Electrical fast transient/burst immunity
test.
 EN 61000-4-5 - Electromagnetic compatibility (EMC) - Part 4: Testing and
measurement techniques - Section 5: Surge immunity test.
 EN 61000-4-6 - Electromagnetic compatibility (EMC) - Part 4: Testing and
measurement techniques - Section 6: Immunity to conducted disturbances,
induced by radio-frequency fields.
MECHANICAL
STANDARDS
 EN 60529 - Degrees of protection provided by enclosures (IP code).
 UL 50 - Enclosures for electrical equipment.