Xerox 4110 User Manual

Xerox 4590/4110 Copier/Printer User Guide
11-22
11. Problem Solving
The Printed Result is not what was Expected
This section describes solutions for situations in which the print
result is different from that expected.
No stapling done Cause The number of pages to staple exceeds 100 or the
number exceeds 50 with staple cartridge for 50
sheets.
No Action Staple-enabled number of pages is 50 or lower with
the staple cartridge for 50 sheets and 100 or lower
with the staple cartridge for 100 sheets. For Z-folding,
staple-enabled number of pages is 10 or 5 sheets
depending on the size of the paper used. For
booklet, up to 15 sheets can be stapled at one
time. Reduce the number of printed pages to 50 or
100 or lower, depending on the staple cartridge used.
No folding Cause The folder is not attached.
No Action Check the options attached with this printer, and
reset the printer configuration
Printing performed with
a different paper size
Cause Paper size provided is different from the specified
tray size.
Action Change the paper size set in the tray, or change print
options to specify a tray that contains the appropriate
size.
The image is cut off on
the edge of the paper
Cause Image exceeds the printable area of the machine.
No Action Increase the printable area of the machine, or
decrease the document print area.
The printed font differs
from the font specified
on the computer
Cause Font replacement is configured on the print driver.
No Action Check the font replacement table.
Cause Non-standard fonts are used for printing.
Action Check the application or print driver settings.
If PostScript is being used, download the required
fonts.
Printing is slow Cause The print mode specifies Print Quality.
No Action When printing image data that has image quality as a
priority, such as pictures, the print speed decreases.
Turn off the quality priority in the print mode.

Xerox 4110 Specifications

General

Brand	Xerox
Model	4110
Category	Printer
Language	English