Xerox 4110 User Manual

Xerox 4590/4110 Copier/Printer User Guide
11-35
11. Problem Solving
016-713  Cause The password set to the mailbox and the inputted
password were not in agreement.
Remedy Enter the correct password.
016-714  Cause Specified mailbox did not exist.
Remedy Create a mailbox or specify the existing mailbox.
016-716  Cause Unable to spool TIFF file because of insufficient disk
space.
Remedy Remove unnecessary documents and users stored on
the printer and then attach the hard disk. When attaching
a hard disk, contact the Customer Support Center.
Refer to “Delete Documents in the Scan & Other Jobs Mailbox” on
page 4-73.
016-718  Cause PCL print data could not be processed as there was
insufficient memory.
Remedy Reduce resolution, cancel 2 Sided printing or N up, and
try to print again.
016-719  Cause PCL print data could not be processed as there was
insufficient memory.
Remedy Increase the size of the print page buffer.
016-720  Cause The PCL print data included a command which cannot
be processed.
Remedy Confirm the print data and try to print again.
016-721 Cause An error occurred during print processing. Probable
causes are as follows:
1. Printing was instructed by Automatic Tray
Selection when Paper Type Priority is set to
Automatic Tray switching Off for all paper in the
Common Settings.
2. ESC/P command error
Remedy For 1, when printing by Automatic Tray Selection, set
one of the paper types to a setting other than
Automatic Tray switching Off in Paper Type Priority.
For 2, check print data.
Refer to “Paper Type Priority” in the System Administration Guide.
016-722  Cause Unsupported staple position is specified.
Remedy Confirm the position, and specify the print data again.
016-723  Cause Unsupported punch position is specified.
Remedy Confirm the position, and specify the print data again.
016-728  Cause An unsupported tag was included in the TIFF file.
Remedy Check the print data.
Refer to “Scan Options” on page 3-38.
016-729  Cause Unable to print because the number of colors/resolution
of the TIFF file exceeds the allowed range.
Remedy Change the number of colors/resolution for the TIFF file,
and specify the print data again.
Refer to “Scan Options” on page 3-38.
Error Code
Category
Cause and Remedy
CPSMO

Xerox 4110 Specifications

General

Brand	Xerox
Model	4110
Category	Printer
Language	English