Properties
183
Connectivity Physical
Connections
Ethernet
Allows you to select the Ethernet transmission rate.
Rated Speed – You can select one of the following
options.
• Auto – Detects the Ethernet transmission rate
automatically.
• 10 Mbps Half-Duplex
• 10 Mbps Full-Duplex
• 100 Mbps Half-Duplex
• 100 Mbps Full-Duplex
MAC Address – Displays the MAC address of the
machine. This is a display-only item.
USB
Allows you to configure the USB port settings.
Auto Eject Time – Allows you to specify the time when
the paper will be automatically ejected from the
machine if no data are sent to the machine.
Adobe Communication Protocol – Only displayed when
PostScript is enabled. Select one of the following
options:
• Normal – Select this when the communication
protocol is in ASCII format.
• Binary – Select this when the communication
protocol is in binary format.
• TBCP – Select this to switch between the specific
control codes when the communication protocols
involve both ASCII and binary formats.
• RAW – Select this when the communication protocol
is in RAW format.
Protocols EtherTalk
Allows you to configure the EtherTalk port settings.
This is only displayed when PostScript is enabled.
Protocol – Displays whether the protocol is enabled or
disabled.
Physical Connection – Displays “Ethernet”. This is a
display-only item.
Printer Name – Enter the EtherTalk printer name.
Printer Type – Displays the printer type.
Zone Name – Enter the EtherTalk zone name.
NetWare
Allows you to configure the NetWare settings.
General:
• Protocol – Displays whether the protocol is enabled
or disabled.
• Physical Connection – Displays “Ethernet”. This is a
display-only item.
• Network Address – Displays the network address in
xxxxxxxx:xxxxxxxxxxxx format.
• Filing Transport – Displays whether two transport
protocols, IPX/SPX and TCP/IP, are enabled or
disabled.
Feature Setting items
To Next Page
Loading...
