Xerox 5222 - Page 185

Properties
185
Connectivity Protocols
(continued)
TCP/IP
Allows you to configure the TCP/IP settings.
IP Mode:
• IP Mode – Select an IP mode from [IPv4], [IPv6],
and [Dual Stack].
General:
• Protocol – Displays whether the protocol is enabled
or disabled.
• Physical Connection – Displays “Ethernet”. This is a
display-only item.
• Host Name – Enter the host name. If you change the
host name of TCP/IP, the host name of SMB also
changes.
IPv4:
• IP Address Resolution – Allows you to set the
method for obtaining the IPv4 address by using the
drop down menu to access the following options.
- STATIC: The user will specify all the addresses.
- DHCP: The addresses will automatically be set via
DHCP.
- BOOTP: The addresses will automatically be set
via BOOTP.
- RARP: The addresses will automatically be set via
RARP.
- DHCP/Autonet: The addresses will be
automatically set by Autonet via DHCP.
• IP Address – Enter the IP address allocated to the
machine in xxx.xxx.xxx.xxx format.
• Subnet Mask – Enter the subnet mask in
xxx.xxx.xxx.xxx format.
• Gateway Address – Enter the gateway address in
xxx.xxx.xxx.xxx format.
IPv6:
• Enable Manual Address – Select the check box to
manually enter the IPv6 address and gateway
address.
• IP Address – Enter the IPv6 address in
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx format.
• Automatically Configured Address 1 - 3 – Displays
the automatically configured IPv6 global unicast
addresses.
• Link-Local Address – Displays the automatically
configured IPv6 link local address.
• Gateway Address – Enter the gateway address in
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx format.
• Automatically Configured Gateway Address –
Displays the automatically configured gateway
address.
Domain Name:
• Domain Name – Enter the domain name.
Feature Setting items