Trimmer options
When using the Trimmer options, always consider the following:
• Booklets exiting/leaving the SquareFold Trimmer Module may contain trim
remnants/scraps from the previously trimmed booklet. This is due to static electricity
build-up and is normal. If booklets contain trim remnants/scraps, simply remove and
discard them.
• The Trimmer feature can be switched on or off based on user preference. When the
feature is switched on, you can adjust the trim setting in 0.1 mm/0.0039 in. increments
depending on your requirements for the finished booklet job.
Note
For the remainder of this section, the machine's UI screen is shown. The individual print
server and print driver screens are not shown. The descriptions given for each of the
Trimmer options are applicable for network print jobs, and apply to any print server/print
driver connected to the machine.
1. Select the buttons to decrease or increase the trimmer setting. Adjustments are
made in 0.1 mm/0.0039 inch increments.
2. The trimmer setting is based on:
• The number of sheets in the finished booklet,
• The finished booklet width size (such as 8.5 in./210 mm or 5.5 in./149 mm),
• The media type (for example coated/uncoated, glossy), and
• The media weight
Note
Important! You may have to experiment with various settings in order to determine the
best settings for your particular job. Also, you may want to run one or more test prints
before running larger jobs in order to ensure the best possible booklet output.
14-7Xerox
®
Color 550/560/570 Printer
User Guide
SquareFold Trimmer Module
To Next Page
Loading...
Need help?
General
