Paper Jams Inside the Press
There are three main module areas of the press where paper jams may occur:
• The Registration area behind the Left Front Door (Xerographic Drawer, Transfer
Drawer, and Paper Handling Drawer)
• Fuser Assembly and Decurler area behind the Center Front Door
• Inverter and Entrance / Exit areas of the Output / Cooling Module behind the Right
Front Door
Tip
Always check the Output Module first for a paper jam at the entrance of the module.
Rotate the green knobs to pull paper through the entrance areas completely. Always
ensure that all paper jams, including any small ripped pieces of paper, are cleared before
proceeding with your print job.
Warning
Never touch a labeled area indicating High Temperature and Caution; this area is found
on the fuser unit or nearby. Contact to this area can lead to burns.
Clearing Jams in Area 2
Important
Before opening any press doors, ensure that the press has stopped printing.
The transfer drawer includes the following jam clearance areas:
• Registration and alignment transport
• Registration roll
• Duplex transport
• Fuser entrance
1. Open the left and center front doors.
Xerox
®
Versant
®
3100 Press7-30
User Guide
Troubleshooting
To Next Page
Loading...
