Xerox Versant 3100 Press User Manual

Clean Fuser Assembly Methods
The Clean Fuser Assembly feature provides two methods for running the routine:
• Clean with Paper: This method runs blank sheets through the press to remove any
residual dry ink / toner from the fuser. The “Clean with Paper” method may be used
any press operator, and does not require administrator login.
• Clean with Felt: This method uses felt that is equipped inside the press to remove
any dry ink / toner from the fuser. The felt is applied against the pressure roll, and
any residual dry ink / toner is removed; this method does not use paper.
Note
You must be logged in as an administrator in order to use the “Clean with Felt”
method.
For more information about the “Clean with Felt” method, refer to the System
Administration Guide for the press.
Performing the Clean Fuser Assembly Procedure
This procedure uses the “Clean with Paper” method and does not require administrator
login.
Note
If you still notice contaminants on the back of the prints after running this procedure,
contact your Xerox Service Representative. Dry ink / toner debris may be coming from
the transfer roll area instead of the fuser.
1. Select the Tools button on the press control panel.
2. Select Clean Fuser Assembly.
3. For Paper Supply, select the paper tray to use.
Note
Any type of paper and size can be used. However, the smooth surface of coated paper
does offer more contact area to the pressure roll.
4. For Number of Sheets, select the number of blank sheets to print (1 to 5).
Note
For best results, run fewer sheets for a multiple number of times. It is more effective
to run one or two sheets for multiple times than to run five sheets for one time only.
This is especially important when running larger sheets, in the short-edge-feed (SEF)
direction, such as 11 x 17 in. / A4 paper.
5. Select Save.
6. Press the Start button.
The system begins the cleaning process.
Note
When running five sheets of paper, the process takes approximately one minute.
When the cleaning process is finished, a “successfully completed” message displays.
7. Select OK.
6-3Xerox
®
Versant
®
3100 Press
User Guide
Maintenance

Xerox Versant 3100 Press Specifications

General

Brand	Xerox
Model	Versant 3100 Press
Category	Printer
Language	English