Xerox Versant 3100 Press - Replacing the Tray 6;7 Feed Rolls

Replacing the Tray 6/7 Feed Rolls
Note
To perform this procedure, the feed roll kit is required. The kit contains all the required
items for replacing the feed rolls.
Important
If replacing the feed rolls for both trays, ensure to obtain two feed roll kits (one for each
tray).
Replace the trayfeed rolls every 300,000 prints or when experiencing frequent multifeeds,
single feeds, or blank prints in the stack of the output prints.
The tray feed rolls include the following components:
3.1. Separator Roll (shown with the feed
roll removed)
Nudger Roll
2. Feed Roll
1. To access the feed components , pull out the tray slowly until it stops.
2. Replace the nudger roll:
Xerox
®
Versant
®
3100 Press6-16
User Guide
Maintenance