Xerox Versant 3100 Press User Manual

Removing the Fuser Module
Warning
You must wait fifty minutes to allow the fuser assembly to cool down to a safe
temperature before performing any fuser assembly procedures.
Caution
When pulling out the transfer drawer to the service position, do not attempt to pull the
drawer further out towards you. Pulling the drawer further out will disengage it from the
rails resulting in damage to the drawer and possible injury.
Caution
Make sure the press is powered off. Do not perform this replacement procedure with
the power on or electrical power supplied to the system. Allow the fuser to cool down
for fifty minutes before performing any maintenance.
1. Power off the press by pressing the On/Off button.
2. When the indicator light stops blinking, open the left and the center front doors.
3. Switch off the main power switch.
Xerox
®
Versant
®
3100 Press6-30
User Guide
Maintenance

Xerox Versant 3100 Press Specifications

General

Brand	Xerox
Model	Versant 3100 Press
Category	Printer
Language	English