a) With the pad facing upward and the felt-tip first, insert and gently push the wand
fully into the ROS window opening.
b) Pull the wand fully out towards you.
c) Repeat the push-in and pull-out motion two or three additional times.
5. Remove the tool, insert it into the next hole, and repeat the previous step.
Continue until you have completed the procedure for all four ROS windows.
6. Replace the cleaning wand tool into the storage area on the inside panel of the left
front door.
7. Close the left and center front doors of the press.
Performing the Clean Toner Procedure
Important
The following procedure is performed only by a person who has press administrator
privileges and is logged onto the press as administrator. Non-administrator users must
contact an administrator in order to to complete this procedure.
Use the Clean Toner procedure after running a low area coverage job which was then
followed by large area coverage job, and thereby experiencing toner agglomerates and
clumps on the output prints. The press runs a full-page halftone to purge the debris and
any residual dry ink / toner from the system.
6-5Xerox
®
Versant
®
3100 Press
User Guide
Maintenance
To Next Page
Loading...
