7. Replace the Bearing Holder Springs to secure the Pressure Roll in place.
8. Ask the administrator to reset the High Frequency Service Item (HFSI) count for this
newly-replaced CRU component at the press Control Panel.
Replacing the Pressure Roll Cleaning Pad Assembly
Caution
Make sure the press is powered off. Do not perform this replacement procedure with
the power on or electrical power supplied to the press. Allow the fuser to cool down for
50 minutes before performing any maintenance.
1. Perform the steps for Removing the Fuser Module.
2. Perform the steps for Replacing the Stripper Finger Assembly.
3. Perform the steps for Replacing the Pressure Roll Assembly.
4. To remove the Pressure Roll Cleaning Pad, use a T15 Torx driver and loosen the one
screw in the front of the press. It is not necessary to remove the screw.
5. Push the pad to the rear of the press and remove it.
6. Install the new cleaning pad. Make sure to align the locking tabs with the holes in
the frame and once the Cleaning Pad Assembly is seated, push the assembly towards
the front of the press against the screw.
7. Tighten the screw to secure the pad in place.
8. Ask the administrator to reset the High Frequency Service Item (HFSI) count for this
newly-replaced CRU component at the press Control Panel.
Installing the Fuser Assembly
Use this procedure to reinstall the existing fuser assembly or to install a new fuser
assembly.
Perform this procedure only after removing the fuser assembly and/or replacing the
other fuser components.
Note
If installing a fuser with a different width fuser, remove the new fuser fromits packaging.
Otherwise, retrieve the fuser that was removed previously and which is sitting on the
Holding Rack.
6-35Xerox
®
Versant
®
3100 Press
User Guide
Maintenance
To Next Page
Loading...
